I purchased and paid for this unit 100% prior to shipping and I am rather surprised at some of the mistakes made with this fabrication.
1 The crusher was advised to me as being able to take an infeed rock of 300mm X 300mm. The opening in the crusher is 275mm X 200mm vastly smaller that I was advised.
2. There was to be three grizzlys supplied 40mm, 20mm and 5mm. I was supplied with a 40, 10. and 5. I did not ask for a 10 but was never supplied the 20mm.
3. The diesel engine is started via a 12V starter motor powered from a 12 volt battery but no facility on the crusher for charging the battery. I was never advised I would have to manufacture and install my own 12V charging system.
4. The multiple Vee drive pulley on the crusher was very poorly manufactured and as a result even drive belt tension could not be achieved. As I need to use the unit I have removed it and repaired the poorly machined component.
5. The angle iron placket that holds the start button had to be relocated